CAMBRIDGE QT Guida di Installazione Scaricare il pdf (Pagina 32)

page 32

Figure 16: Standard view of the ENFD conguration section.

The diagram above shows the window as it appears and is learning

the network conguration.

After the 15 minutes are expired and the system is fully installed, it

is time to enable fault detection if you desire. It is not required for

proper operation. The window shown on the next page shows that

after the 15 minutes have expired there is a dropdown in the upper

right corner that allows 3 actions:

1. Refresh settings - this is used just before enabling ENFD to

make sure any setup data is cleared and proper measurements

will be taken. This can also be used after an error has been xed

and a new test can begin.

2. Enable fault detection - once this is selected, select the zone

in which you want the emitter run monitored, by choosing the

submit button.

3. Disable fault detection - this is used to turn off the feature by

then using the submit button for each run

If there is a fault, an error code 4 will be displayed for that failed zone

in the status block.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Nessun commento

CAMBRIDGE QT Guida di Installazione Pagina 32